Q1：When the Scalar Light comes on in the Receiver, what is it responding to:  Scalar energy, or is it sensing electromagnetic energy?

A: The LED on the receiver only shows one thing conclusively.

That there is power transfer over the air. Enough power in fact to raise the voltage of the receiver coil to the point where it can illuminate the LED.

This can be done with a Scalar or EMF tune.

How the LED responds when you attempt to block the power transfer from the transmitter can give clues to whether you have a Scalar of EMF based tune.

Since scalar passes through everything, putting your hand in front of the receiver lid so as to intercept the transmission from the transmitter, should have little to no effect on the LED. If it is EMF tuned, your hand will absorb a large amount of energy from the transmitter affecting the LED significantly.

The link cable wire only carries current back to the transmitter from the receiver to provide a much easier common ground than the air would. In fact, it is not even needed, although tuning distances are incredibly short without it, given the amount of power that the transmitter is using.

Following the tuning process starting at 8 MHz and working your way down gives you the best chance at establishing a scalar field as it is the higher tuning point of the two resonant points found when working at standard 6 to 12 feet distances. Long haul tuning setups are completely different, and in fact, can be too far apart to establish an EMF based tuning anyhow.

The LED on the transmitter is to help you get into the zone, and the LED on the receiver is to help you finalize the tune. The LED on the receiver should remain off under normal operation to prevent power siphoning.

For more details, please check this link:
https://www.facebook.com/groups/spooky2scalar/posts/979508445956047/

Q2：Does the effectiveness decreases after a certain distance the boxes are apart?

A:The minimum recommended distance between the two units is 6 feet. Try to keep at least 2 feet away from the Transmitter and 1 foot away from the Receiver. When you do BFB scan, try to keep the two units close together so that the scan results are not affected by other items inadvertently entering the scalar field.

There is theoretically no limit to the maximum distance between the two units. The further apart the two boxes are, the bigger and stronger the scalar field is. However, more items will be within the field, reducing the strength. Also, a very long link cable will lose some energy.

The scalar field is not blocked by walls. You can put the two units in different rooms to get a bigger and stronger scalar field. For best results, keep the two lids facing each other.

For more details, please check this link:
https://www.facebook.com/groups/spooky2scalar/permalink/884727278767498/

Q3：My understanding is we can’t have more than one person in field.Why or why not?

A:People who live in close harmony often have their subtle energy fields (aura) sharing. Then physical problems get shared as well. This is called quantum entanglement.Your energy has already been quantum entangled with family members and friends, so you can share the scalar field with them. We do not recommend sharing the scalar field with strangers, or people with serious diseases.When the scalar field is shared, it can sometimes create symptomatic “cross-talk” between beings. This is why you shouldn’t share the field with someone who is very ill, as you may inadvertently share some of the “information” about their illness.

If you don’t want the scalar field to affect others, keep the two scalar units at a minimum distance. At times, it is impossible to avoid sharing the scalar field, but this is not necessarily a problem.

Q4:How would an imprinted crystal be use? I understand drinking the water but unsure how to use something like a crystal.

A:1.You can use crystals with scalar. Put it on the Transmitter Output Coil. It’s the same as imprinting distilled water. You can carry the crystal around with you to receive scalar energy throughout the day.

2.You can charge crystals in sun light (part of the sun energy is no doubt scalar), you can charge them in Spooky2 Scalar field. I also like to believe that having a crystal on my body is like having a candle like source of scalar energy, while being in Spooky2 filed is like sitting at the campfire.

If you want more details, please check the link:
https://www.facebook.com/groups/spooky2scalar/permalink/458609054712658/
https://www.facebook.com/groups/spooky2scalar/permalink/343131876260377/

Q5: Does angleing the boxes in the room have a better affect? If there isn’t enough room to accomplish this, can setting them up on each side of the bed work as well?

A: 1.Yes, it’s okay to set the boxes up on each side of the bed.The minimum recommended distance between the two units is 6 feet. Try to keep at least 2 feet away from the Transmitter and 1 foot away from the Receiver. The further the two boxes can be apart from each other, the bigger / stronger the field will be as well. The field is not blocked by walls.

2.The scalar field can pull energy in from the Earth energy fields.Only way one can explain how you can arrive with a net positive on the receiver.I’ve read Meyl’s accounting of such power gains and then ended up gaining four times more power in my whole house field than what the transmitter is putting out.You can measure the balance if you have an external coil tester.
Approach the coil on the transmitter from the bottom right corner until the field is strong enough to illuminate the LEDs. Take note of the distance to the center of the coil.Then do the same on the receiver.If your coil lights up at the same distance, you have a balanced field. If it lights up with a shorter distance, you probably can fine tune your setup.If it lights up farther away, you have more power at the receiver than the transmitter.If the distance is double, that’s four times as much power.

For more details, please click this link:
https://www.facebook.com/groups/spooky2scalar/permalink/350934705480094/

For more details, please check this link:
https://www.facebook.com/groups/spooky2scalar/posts/980379382535620/

Q6: To imprint vitamin C into water, would you place the vitamin C on the transmitter and the water on the receiver?

A: 1.If you want to send the effects of an essential oil, supplement or drugs, etc, in your body or into something else, place the substance on the receiver coil.

2.If you wish to imprint information into water for drinking, place the water on the transmitter coil, and the modulated information substance on the receiver coil.

3.If you want to imprint frequency into water using a generator, you can place the water on the transmitter coil after you connect a Spooky2 generator to the transmitter.

Q7: Can the scalar machine work on clearing energy blockages and balancing Chakras?

A:Yes.Despite interruption by blockages, our body retains the memory of healthy energy through cell communication.Cells use scalar energy to communicate. Blockages disrupt this natural communication. Scalar energy introduces energy, which restores this communication, exposing the diseased cells to the body’s defenses.

Mitochondria are the “power stations” of cells. Scalar energy charges the mitochondria, giving your cells much-needed energy to open and remove the blockages. Once the blockages are removed, our body will restore the flow of Chi back to a healthy state. Just as removing the fallen tree from the river restored water flow.There is a saying in traditional Chinese medicine: “Where there is free flow, there is no pain or disease.”

For more details, please check this link:
https://www.spooky2scalar.com/scalar-energy-for-human-energy-field/
https://www.spooky2scalar.com/how-to-balance-your-blocked-chakras/

Q8: When use DNA and photographs to send the frequencies to the person, where should we put them?

A:If you want to use a photograph with the scalar boxes you are best off placing a real photo on the transmitter coil.

This provides both the entanglement properties and puts that entanglement into the magnetic scalar field to allow biological information to be written. If you don’t trust your photograph, use a DNA sample.

If you use DNA, place it on the transmitter coil so it is in the magnetic scalar field and actually can forward the biological information to the target. If you place DNA in between the boxes, you are relying on the sample having a real experience in the field, and forwarding that experience to the target.

There is a major difference. The former allows the instruction book to be sent, and the body can use that information to do work. The latter relies on the DNA sample having a direct experience in the field, for which it will give a second-hand accounting to the body which may be able to use that information to do work.

For example, if you are trying to target a pathogen with information it is better to send that information directly to the body. Then the body can target the pathogen wherever it exists. When you place DNA between the boxes, if the DNA doesn’t contain the pathogen, then it can’t experience that pathogen going through a process to give the body an accounting of how that pathogen reacted essentially wasting your time.

Also, if you have no biological information in the field, you are wasting your time placing photos and/or DNA in the system since the scalar energy can not be sent remotely.

If you place a photo in the field between the boxes, you are essentially again wasting your time as a photo will not have much of a direct experience in the field worth sharing with the target.

For more details, please check this link:
https://www.facebook.com/groups/spooky2scalar/posts/1132996807273876/

Q9:Can the person be placed between the scalar cases in the direction of head and feet?

A：Yes. Just keep in mind that the boxes themselves do emit some EMF and if you are sensitive, you may wish to set it up so that you have at least 1.5 feet or more between your head and the box.

For more details, please check this link:
https://www.facebook.com/groups/spooky2scalar/posts/989965638243661/

Q10: The longer you sit in the pure scalar, the better?

A: In general, we recommend using Spooky2 Scalar for at least an hour a day. For pure scalar mode, you can also use it all night.

Let’s see what our users say:

1. Full night, every night.
2. I sleep in it every night with vit c and quartz crystal. Best sleep ever. 7-8hrs continuously, not waking up at all deep sleep. Love it.
3. In my case, every 2 days for 6 to 8 hours during the night, I do a hunt and kill while I sleep. I sleep much better and my neck pain and headaches have completely disappeared and never reappeared.
4. I just started sleeping in it right away. No herxing. I also do a hunt and kill twice a month or so.
5. I also sleep nightly in the scalar field. I’ve never experienced herxing with it. Sometimes I Set it up to cover several rooms and keep it running for days. I love it! My sleep is better than I’ve ever had.
6.  I’ve slept in the field every night for about 15 months. No herxing issues at all. I also sat within it for many hours during the day for the first 6 months or so.

For more details, please check this link:
https://www.facebook.com/groups/spooky2scalar/permalink/669502243623337/

Q11:Can the scalar device be used as a replacement of the Gen X pro or the XM generator?

A:No, they are used for two different ways.Gen X pro or the XM generator uses the rife system, and the principle of Spooky2 Scalar is scalar energy.

1.Rife Frequency is the MOR frequency for a pathogen or an “entrainment” frequency for an organ or system, or a resonant frequency for a specific substance (usually a toxin) to shake it loose and allow the body to move it out. This frequency may be sent to the body using any of the transmission modes, Plasma, Contact, Remote, Laser, PEMF, Radionics – and whatever else comes out later. More information here: https://www.spooky2-mall.com/how-it-works/

2.Scalar waves are able to restore cell communication, exposing the diseased cells to the body’s defenses, and giving your cells much-needed energy to open and remove the blockages. It’s good for boosting your immune system so that your body is better able to fight or rebuild itself. A scalar field is created between the two boxes (Transmitter and Receiver) to restore your health. For more information about scalar, you can click this web page: https://www.spooky2scalar.com/scalar/.

Q12:Can I imprint large amounts of water (18L water cooler jug) with the scalar? Can i put the water jug in the scalar field between the transmitter and receiver?

A: 1.One of our users once tried to imprint 2L of water on the Transmitter coil, but when he turned on the Receiver Light, the machine refused to light up the red LED.Another user tried to imprint 1L of water, and the Receiver Light on the machine successfully lit up red.18L of water may be too heavy. We recommend that the amount of water for each imprint is about 500ML.

2.When printing water, the water needs to be placed in the transmitter coil, not between the transmitter and receiver.

Q13:Is the Scalar Remote application stronger than the regular Remote?

A:1.Spooky2 Remote is extremely low power. The information is transferred using quantum entanglement of DNA. Spooky2 Scalar works directly with the target, using higher power levels.

2.Generally, we recommend sitting or lying in the scalar field to get the scalar treatment. But some of our users also try using Spook2 Scalar remotely and get great results. You can also give it a try.

Look what our users say:

1. I put a DNA sample and photograph in the middle of the scalar field, then put frankincense oil on the receiver, it transferred to the remote person and worked well.
2. I had a friend that had lung issues from you know what (can’t mention the virus he had on here) and was in the hospital. He was released but was still going downhill. I decided to try his photo in the middle of my scalar while he lived about 7 miles away from me. Didn’t use any DNA just photos.
   In 3 days his wife said he is getting well really quick. In a week he was eating again. In 2 weeks he gains most of his weight back and is doing excellent. He’s in his mid-70s. I just recently removed his photo and will see how he will do. What I used on the receiver was Meso Silver, Vitamin C, and Vitamin D, and running GX frequencies connected to my Scalar for California region for you know what.
3. I have Scalar, Plasma, and remotes. I have gotten an upper respiratory issue and tried my nail DNA and my photo in the Scalar field. Knocked it out in 4 days. Unusually would run remotes but wanted to try the photo and DNA on me. If you ask me it worked faster than remotes.

For more details, please check this link:
https://www.facebook.com/groups/spooky2scalar/permalink/895035401070019/