Q1: Can Spooky 2 reduce blood pressure?

A: Yes, it is possible that the blood pressure is a symptom of some other root cause…

If your kidneys are involved, try running this: Hypertension Renin Induced CAFL
It’s also a good idea to work on your kidneys:
Kidney Function Balance XTRA
Kidney Insufficiency CAFL
Kidney Stimulation XTRA
Kidney Tonic General CAFL
Kidney PROV

For more details, you can check the link: https://www.spooky2support.com/hc/en-us/articles/216249808-Advise-regarding-settings-for-high-blood-pressure-

Q2: How long does an imprinted holographic sticker last? Any suggestions on how to keep the holographic stickers to stay on better?

A: Imprinted holographic stickers can last for a very long time. They can last as long as they do not get wet, worn out, or exposed to the sun and strong magnetic fields.

Many like myself put them in a plastic coin holder and keep them in a pocket. They last longer. I use a plastic coin holder or a very, very small ziplock baggie.

More details here: https://www.facebook.com/groups/spooky2/posts/2583561988472355/

Q3: I’ve just received Spooky2, can it remove blood clots? How to smooth the muddy blood.

A: 1. There have been good results with Cold Laser on wrist and blood cleansing programs.

2. That body needs earthed. Earthed I believe they are referring to grounding; walk barefoot in the grass. Or if it’s too cold, visualize your legs being a tree trunk and your roots going into the earth. Either way, it helps to ground out the bad energy build up in the body.
https://www.youtube.com/watch?v=cRW0XO2xWn4

3. Serrapeptase is good for mopping up and there is a frequency for it too.

4. I would imagine that oxygen would be good. There is a blood cleaning program.

5. This is known as “Rouleaux” btw. The wrist item is purportedly good for this. I can’t vouch for whether it is or isn’t. Btw I would think cold laser would work for this as well since it is similar. Also, check YouTube for Rouleaux.

6. PEMF at 7.5 Hz on the wrist for at least 8 min (Time it takes for blood to circulate through the body and back to that spot) The cells are clumped together possibly because of weak charge on the outer of the cell membrane PEMF has the potential to charge the cells so they all repel each other.

For more details, please check the link:
https://www.facebook.com/groups/spooky2/permalink/1217299118431989/

Q4: I am the only human but I have a cat and a dog. Is it OK to run scalar overnight with them?

A: It is not recommended the share the field with pets if you are in the Scalar field. When the scalar field is shared, it can sometimes create symptomatic “cross-talk” between beings. This is why you shouldn’t share the field with someone who is very ill, as you may inadvertently share some of the “information” about their illness. In this regard, pets are kinda an unknown quantity.

But if you are not in the field, then by all means let them have a dose of it. They love it and will often fight you for a go in it! And don’t panic if the cat jumps on your lap whilst being in the field. Just shew her away and continue your pure treatment.

For more details, please check this link: https://www.facebook.com/groups/spooky2scalar/permalink/826731081233785/

Q5: If nail clippings are infected with a fungus or polish or stored in the freezer, will they still work for the remote?

A: We suggest not to put the nails with a fungus together with other healthy nails for treatment, it may infect others due to quantum entanglement.

1) If nail clippings are infected with a fungus, the DNA of the individual and of the fungus should both be present and receive the signals, as far as I know.

I think fresh nails are always best, but I do not have an answer as to whether nails may be frozen or how long they would last if frozen.

• Polish doesn’t contain DNA, so should be no problem.

As far as I know, the remover doesn’t have DNA – and isn’t going to take the DNA out of the nail, so should be OK as well.

For more details, please check:
https://www.facebook.com/groups/spooky2/permalink/974745936020643/

Q6: Is there anything we can do to mute/stop the beeping when using the cancer protocol with the phanotron? It is VERY difficult to sleep with this beeping going on and off all night.

A: The sounds we hear are the harmonics being generated that are in the sound range.

Can’t stop it from happening other than not generate that specific frequency which results in that harmonic.

A lot has to do with the fact that we are using a square wave (odd harmonics) and a modulator which creates the sidebands.

For more details, please check the link:
https://www.facebook.com/groups/spooky2/posts/2096207100541182/

Q7: For people with pacemakers or hip replacements can you use remote on them?

A: No contact mode Rife machine should be used with anyone who has a pacemaker. The electrical energy entering the body can interfere with the pacemaker’s electronics. We recommend Remote Mode as it is much safer. 

Plus, here is one customer’s experience, you can have a look:
My sister had a double hip transplant and I use it on her with no issues. The only thing would be a warning for pacemakers not to use contact mode (even though pacemakers made after 1994 apparently will not be affected). I also have clients with knee replacements with no issues.

For more details, please check the link:
https://www.facebook.com/groups/spooky2/posts/2027501350745091/ 

Q8: Can I touch the plasma tube to the head where there is cancer?

A: Yes. The plasma is safe for the head, including a head with cancer.

For more details, please check the link:
https://www.facebook.com/groups/spooky2/posts/2170569003104991/

 Q9: What is the best transmission mode when lung cancer has metastasized to the brain? Which transmission can pass through the skull ? Can plasma do it ?

A:  Contact and plasma are the ways to go.

Here is one customer’s experience:

I had cancer pass to my head, brain area 4 years ago from breast cancer and used contact mode to take out the cancer.
Be very careful in how long you use the tens pads in this mode. I had it running over 5 hours but then had a strong herx effect. Keep contact mode under 2 hrs at a time!

For more details, you can check the link:
https://www.spooky2support.com/hc/en-us/articles/360049700013-What-is-the-best-transmission-mode-when-lung-cancer-has-metastasized-to-the-brain-Which-transmission-can-pass-through-the-skull-Can-plasma-do-it-

Q10: Can you run the Terrain protocol and Cancer at the same time?

A: Terrain is best run as a standalone however if you wish to help the flow of it you may also run Detox maintenance / support programs in conjunction.
To run Terrain and a Cancer protocol at the same time may be too much to a sick body to handle.

For more details, please check the link:
https://www.facebook.com/groups/spooky2/permalink/1421072781387954/

Q11: My spooky tube sometimes does not have any rays and sometime it doesn’t flash, is this OK?

A: Electrical noise may be causing the problem. Make sure the white high voltage wires and plasma tube are as far from the generator as possible. Use the special USB and BNC filter cables provided with your Spooky Central. If you do not have the BNC filter cables these can be obtained from spooky2-mall.com.

Q12: If you scan with contact, you cannot run them by remote?
A: 1. It is a user choice. Remote is more convenient since there isn’t a physical connection to the gear. Both are effective for most people.

2.We usually run results on Remote, but if we’re looking for a strong “quick fix”, we choose to run them in a Plasma session (followed by Remote 24/7 until the next scan).

One thing though, the Scalar only scans up to 50 kHz. For this reason, you might be better off doing a TENS pad scan.

For more details, please check this link:
https://www.facebook.com/groups/spooky2/permalink/1094465620715340/

Q13: Does the pain medicine go on the transmitter or the receiver of the scalar?

A: The energy flows from the transmitter to the receiver, then back. There is no scalar field until it hits the receiver and it returns back to the transmitter.

Therefore, in order to add a substance’s information to the field, the first entry point is the receiver’s coil (input coil). That information is then carried back to the transmitter. Once at the transmitter, the information can be imprinted to whatever is on the transmitter’s coil (output coil).

Normally it’s suggested to run Scalar for at least 1 hour during the day. If you put drugs on the receiver box, please pay attention and see if you have any discomfort. Drugs may have side effects and different people may have different reactions. For natural supplements, like essential oils and vitamins, there’s no limit to that. And you can use pure scalar for overnight treatment.

For more details, you can check the link: https://www.spooky2support.com/hc/en-us/articles/360041018034-Can-you-explain-why-it-s-recommended-to-put-water-to-imprint-on-the-transmitter-while-putting-substances-on-the-receiver-coil-

Q14: Why doing a baseline before general scan my results are much lower than before just doing the BFB alone?

A: 1. This indicates that Baseline is working well for you. Most viruses are 800 kHz or lower. Only some very small viruses are above this frequency. So I think most of you scan results before are from the environment (WIFI, radio, TV, cell phone, etc.). Also, the old scan of 18 MHz was reduced to 1.8 MHz in the new software (20190116), because the higher frequencies are mostly from electronics. To sum up, no need to worry, your scan results are more accurate after using Baseline.

2.That’s with threshold set to 0.2 Samples set to 5.

For more details, please check the link:
https://www.facebook.com/groups/spooky2/permalink/1204997376328830/

Q15: How do I narrow down my Reverse Look Up results? What’s the theory behind Reverse Look Up?

A: Just want to take a minute to point out what you are essentially doing with the reverse lookup.
When you put in your frequency, the program will look at any database set that has a frequency that is within your % tolerance.

For more details, you can check the link: https://www.spooky2support.com/hc/en-us/articles/1260803289369-How-do-I-narrow-down-my-Reverse-Look-Up-results-What-s-the-theory-behind-Reverse-Look-Up-