Q: Is it okay to run Spooky on contact mode with Tens overnight?

Answer: Some people run contact through the night.

Go to your programs tab and look at the bottom of the page and you’ll see the options section repeat sequence is the 3rd option in that section. set it to however many times you want it to repeat the sequence. I think you can even put in 0 for it to repeat forever until you stop it.

CAUTION: Some people develop burn-type reactions at the Contact points so PLEASE do this AFTER knowing that you can run Contact for longer times safely.

If you suffer burns or stinging, just set the option to reduce amplitude for frequencies of <10khz which helps.

For more details, please check the link: https://www.facebook.com/groups/spooky2/permalink/1755721231256439/ 

Q: How should I deal with painful reactions when I use the TENS pads?

Answer: The Contact presets can be shocking if run offline. You might try the Colloidal Silver port of the Boost to reduce the current. You may have to alter the preset for offline usage to reduce the Amplitude.

Alternatively, if you run the Contact presets online, and connect your TENS cable to either the HIGH PWR or Colloidal Silver port, you will not get shocked, as the online version uses a carrier wave on Out 2. This makes it possible to use the HIGH PWR port and not get shocked, plus you get deeper cellular penetration of the frequencies because of the dynamic +1MHz carrier.

Q: Can you use multiple generators with contact mode?

Answer: 1. You can only use one set of tens pads on the body at one time.

Current can be additive within the body, which may cause damage within the body. Some frequencies are above what typically stimulates nerves or muscles, so one may not realize the damage is occurring or has occurred until after the session is over. Just not a good practice.

The signal from one device may go to another and the result causes some malfunctions within the gear. While I think this would be rare, it could happen.

2. The issue with using two sets of TENS pads (meaning 4 individual pads) with Spooky generators is this creates a short circuit to the ground, and this causes the generator to not output anything, though the generators are not damaged.

If you had two battery-powered inverters and plugged each Spooky generator into those generators, then there would be no common ground, and this would work.

With the HeaWea MicroGen, if you have two of them since they run on batteries, there is no common ground, and this is safe.

For more details, please check the link: https://www.facebook.com/groups/spooky2/posts/2070261593135733/ 

Q: Should we use grounding mats during contact treatment?

Answer: 1. Do not use a grounding mat or pads while doing contact. This creates a path to the ground for the electricity to leave your body. Also, do not ever do 2 contact treatments at once, using 2 generators. This has the same bad effect.

2. Never even lay on a grounding mat near electrical equipment you become like an antenna for that energy to go into the ground through your body. Grounding mats are good at least 4 meters away from electrical sockets then you fine.

For more details, please check the link: https://www.facebook.com/groups/spooky2/permalink/1652309351597628/ 

Q: Why can’t the TENS pad be placed on the face?

Answer: You want to protect the brain, eyes, and thyroid. That’s why you don’t Rife on the face. Never place TENS pads above the neckline at all. If you want to treat the head, place tens pads on the shoulders below the neckline. Often lower frequencies you will feel. Also if you are inadvertently tackling a pathogen, it will react making you feel the tingles more. It is also possible that the nerves and muscles are reacting to the lower frequencies. This is still safe though.

For more details, please check the link: https://www.facebook.com/groups/spooky2/permalink/1653410731487490/ 

Q: If I turn the power down or move the contact connection to colloidal silver output, do either of these options reduce the effectiveness of the frequencies?

Answer: If you use the CS port over the High Power Port, the current is limited which will reduce the frequencies ability to resonate with your muscles/nerves. The only thing lost is high-frequency harmonics which won’t be very high if you are in the range you can feel frequencies.

You will only feel it if it is resonant, and this only happens below 10,000 Hz.

You can avoid this sensation by running higher frequencies, or using the CS port without worry.

If you lower the amplitude, you run the risk of lowering it to the point where it will not penetrate the body and thus reduce efficacy.

For more details, please check the link: https://www.facebook.com/groups/spooky2/permalink/888517361310168/

Q: How to use contact mode correctly?

Answer: 1. The socks and glove can stretch. If they are not a snug fit they can cause burns. Please check before use.

For more details, please check the link: https://www.facebook.com/groups/spooky2/permalink/1251964111632156/ 

2. If you are using TENS pads, Please replace TENS pads regularly to make sure they have good contact with the skin.

Whatever contact mode you are using: Make sure it is not 100% offset in the setting. Please strictly follow.

3. If you are dehydrated & the body is acidic then the contact mode can cause burns. To avoid this properly hydrant (i.e. drink plenty of water), use a contact cylinder (as palm skin is thick), moisturizer your palms with salt water, or better still place a wet (with a salt solution) kitchen paper towel on the cylinders. As Spooky2 contact mode is able to alkalize the body hence after a week or two of regular use of cylinders the skin contact mode is less likely to cause burns.

4. After your skin burns, suggest you try the cold laser daily for 30-minute sessions and colloidal silver for fast healing.

Q: Why can’t we put TENS Pads on joints?

Answer: It’s because of the possibility of electrolysis within the synovial fluid.

Q: When is a good idea to use larger TENS Pads than normal ones?

Answer: Spooky2 Large TENS Pads provide better contact with your skin, and more area for the power to enter into your body, making contact sessions more comfortable. For most instances, large Tens pads would be ideal.

For small areas which are hard to place large TENS Pads, we recommend using small Spooky2 TENS Pads.

For more details, please check the link： https://www.facebook.com/groups/spooky2/permalink/1359432577551975/ 

Q: Can I run Contact with socks and TENS Pads at the same time?

Answer: You should not run two separate machines doing contact treatment (sending frequency via electrodes, socks or so) on the same body. The frequencies will add up to each other and you will get new frequencies.

The pathogens that go into resonance with the original frequencies might not go into resonance with the combination anymore.

However, you can run remote and contact at the same time.

For more details, please check the link: https://www.facebook.com/groups/spooky2/permalink/1435670389928193/ 

Q: How do we determine the amplitude when using contact mode and what does that mean?

Answer: Contact needs enough voltage to penetrate the skin in order for it to penetrate through the body. The recommendation is between 14-20v.

Enable reduce amplitude < 10 kHz so that in the case of low frequencies, it does not shock the system terribly — low frequencies can interact with the nervous system.

For more details, please check: https://www.facebook.com/groups/spooky2/permalink/537374583091116/ 

Q: How many times I can reuse TENS pads? Can the TENS pads be reused?

Answer: 1. About 20 times. They can be reused. You can use it until TENS pads are not sticky. After each use, you can stick them onto the plastic sheet that they originally came with.

2. They will last as long as you can keep them sticky. Over time they will either pick up too much residue and/or dry out. Keeping them stored in the bags when not in use will prolong life. You can gently rinse the sticky side with water and let it dry for a day, while stuck to the plastic storage square, to remove excess dead skin, etc. This will prolong their life once they start to lose their stick. It has also been reported that you can use essential oil to keep the sticky side hydrated and clean prolonging life.

For more information please check this link: https://www.facebook.com/groups/spooky2/permalink/757258204436085

Q: What’s the difference between Spooky Hand Cylinder and Spooky Tens Pad in contact mode?

Answer: There are mainly two differences.

First, compared with the Tens Pads, hand cylinders have a broader contact area with the skin. Also, you can do a foot bath with the hand cylinders, dipping them in the water with the feet (obviously being careful not to allow the electrical contacts anywhere near the water!) thus increasing the contact area with the skin even further.

Second, the Tens Pads hold better for long programs than trying to hold the cylinders, except when using a foot bath.

Please use them based on your situation.

For more details, please check those links:

1. https://www.facebook.com/groups/spooky2/permalink/657955167699723/,
2. https://www.spooky2-mall.com/blog/spooky-tens-pad-and-spooky-hand-cylinder-q-and-a/

Q: If you are targeting a specific area, such as the kidney, would you place the tens pads one on the kidney and one on the abdomen? So frequencies would pass through the specific problem area?

Answer: This sounds reasonable to treat one kidney or the other. If you want to treat both, you might try placing the pads on each side just above the hip bones.

For more details, please check:

1. https://www.facebook.com/groups/spooky2/permalink/682599251901981/;
2. https://www.spooky2-mall.com/blog/where-to-place-tens-pads/

Q: What is the reason people with metal in their bodies can not use contacts? Can they not use contacts anywhere or just not over the metal screws or other metal parts?

Answer: We don’t use contacts when we have metal parts within because the metal will conduct more easily than the flesh, so the current will tend to flow through the metal, which could cause sensations (or in extreme cases, burns) where it enters and leaves the metal. This may also alert the body to the “foreign matter” and be a cause for rejection. Plasma and Remote are the modes that should be used in these cases.

For more details, please check: https://www.spooky2support.com/hc/en-us/articles/115004087328-What-is-the-reason-people-with-metal-in-their-body-can-not-use-contacts-Can-they-not-use-contacts-anywhere-or-just-not-over-the-metal-screws-or-other-metal-parts- 

Q: Is SC Contact more powerful than Contact to the booster on the generator?

Answer: The Central Contact and the Generator Boost Contact really do two different tasks, so aren’t very comparable. The Central Contact provides a very high voltage, very short spike to trigger cells to allow the Plasma energy into the cells easier so the Plasma is more effective.

The Generator Boost Contact delivers the electrical current at the frequency as a killing or healing modality of its own, rather than as a support role.

For more details, please check the link: https://www.facebook.com/groups/spooky2/permalink/758922500936322 

Q: What is the Difference between Healing and Killing frequency?

Answer: A frequency will resonate and do its job where needed, regardless of whether you think it’s healing or killing. When deciding which types of frequency to run in the Spooky2 generator, you must understand what caused or triggered your health problem beforehand.

You can learn the details from this blog: https://www.spooky2-mall.com/blog/how-to-distinguish-healing-and-killing-frequency/. 

Q: How to run a biofeedback scan?

Answer: Spooky2 Biofeedback Scan is a powerful tool for listening to your body and discovering what frequencies are best suited for you. To suit people with different needs, there are currently four ways to run biofeedback scans. You can learn more details via this blog: https://www.spooky2-mall.com/blog/four-ways-of-running-biofeedback-scans/.